The Barix Instreamer device transmits the audio into our MP3 Streaming service and into your conference bridge when it is turned on or when the volume level is high enough. It is available for sale in Canada from us or from Montezuma Sound in the USA.
For more information on the Barix Instreamer, check out the Data Sheet.
You will want to be sure all changes are made only under the advanced settings on the Instreamer device. If changes are made to the basic settings portion, it will erase the necessary advanced settings.
...
(If you need more information to determine your Instreamer URL, see their documentation.)
Note: The settings displayed in this guide should remain accurate. However, screenshots of the Barix Instreamer web interface depicted below are subject to potential change.
...
In the Audio Tab of your advanced settings, ensure that the following settings are configured:
Input Source: Line mono
Audio Format: MPEG1/44.1kHz (MP3)
MPEG bitrate mode: We recommend CBR but you can adjust.
MPEG CBR bitrate: 128kbps is recommended but adjust as you see fit.
A/D amplifier gain: Adjust this as necessary to get the appropriate volume on your streaming and call out.
MP3 Bit Reservoir: ListenToChurch recommends setting this to ‘use’
...
Trigger Level, Pre Trigger Start and Post Trigger Play can be set based on preference. Stick to defaults unless you are familiar with audio settings.
Buffer Underrun Mode (TCP): set to ‘skip’
Stream Packet Strategy: set to ‘optimal package’
UDP Tx source port: 0 0
...
SHOUTCAST/ICECAST SETTINGS
...